Forum Replies Created
-
AuthorPosts
-
loxai
KeymasterYou might have the fake 3D option enabled in Trinus. If the content (yt) is already in sbs, you do not need the fake 3d.
Speed wise, try a different connection (ie. better wifi or via usb)February 23, 2021 at 8:28 am in reply to: Sent a mail to support about Trinus PSVR but got no answer .. #8891loxai
KeymasterHi, I haven’t found any pending request in my mailbox (spam included).
Please try sending through a different e-mail address (in case it is filtered out) or through private message on facebook.loxai
KeymasterYou will need to convert mouse to analog stick movements. This may help: https://forums.pcsx2.net/Thread-Resolved-Using-Mouse-axis-movement-as-analog-stick-Lilypad-0-9-9
loxai
KeymasterIf you don’t want the mouse head tracking conversion, disable it in the VR Conversion tab
loxai
Keymastertry running SteamVR setup again, with the headset facing the right direction
loxai
Keymasterchange the Trinus SBS option as necessary.
loxai
Keymasterare you using original usb cable?
did the psvr driver install successfully, and is appearing in Device Manager (as shown in the troubleshooting page)?loxai
Keymastercheck suggested solutions here: https://www.gog.com/forum/gothic_series/gothic_2_mouse_problem
loxai
KeymasterHi, support e-mail is indeed the right channel for such request
February 24, 2020 at 1:51 am in reply to: 1.0.7 has serious bug since november, 1.0.6 doesn't work due to suicide switch #8583loxai
KeymasterI do not know the reason for that bug regarding double image and don’t have a suggested solution for it, sorry.
if by time bomb you refer to the forced update, no there isn’t one anymore.February 23, 2020 at 9:37 pm in reply to: 1.0.7 has serious bug since november, 1.0.6 doesn't work due to suicide switch #8577loxai
Keymasterresetting at 180 is fine. fwd is whatever is set in SteamVR config.
double image can be removed at higher display refresh rate (some SteamVR settings may help too), but it’s inherent to the Trinus SteamVR driver. same goes for the red screen: these are limitations with the driver, which will show up depending on software/hardware combinations.loxai
KeymasterIt’s not dead (see my reply to your other post) just slow dev, I have to work on other projects.
February 20, 2020 at 9:59 am in reply to: 1.0.7 has serious bug since november, 1.0.6 doesn't work due to suicide switch #8570loxai
KeymasterI’ve been preparing an update to fix some of those issues.
Please try and let me know how it goes for you.
http://trinusvr.com/files/TrinusPSVRSetupBuildTest.exeloxai
Keymastercontacta con soporte
loxai
KeymasterHi, sorry about that guys, had a problem with the update system, but it is now resolved. You will need to update Trinus server (version 2.1.9)
-
AuthorPosts